After you run the gcode, disconnect the printer from Simplify and open Arduino 1.0.6 and load the firmware and start adjusting the offset until the two squares overlap. Since we want the 3D Printer to use the auto bed leveling sensor and probe the surface before each print, we need to tell it to do so via the Start script. Make sure to use two different colors for each extruder this will make it easier to spot any deviation that has to be corrected.ģ.

Once you download the gcode, connect the printer to Simplif圓D and run the gcode. To calibrate the extruders you need to adjust the offset in the firmware so that both extruders print the square from exactly the same spot and make sure they overlap.Ģ. The gcode is set up so that each extruder will print a square.

If you can`t find the sticker with the offset values on the printer please install the firmware with the default values and then follow the steps below and adjust the hot end offsets.ġ. The first step is to download the gcode you can find attached to this solution. In the following solution you will be instructed on how to calibrate the offset for your Creatr Dual hot ends. Hello and thank you for choosing the Creatr for your printing needs. Modified on: Wed, 11 Mar, 2020 at 8:51 AM Learn how to use the OctoPrint software to calibrate and control your MakerGear 3D printer. Solution home Creatr (XL) 3D Printer Maintenance Calibrating offset between hot ends on the Creatr (XL) Simplif圓D profiles for your MakerGear Printer M3 Setup.

How to calibrate simplify 3d model